ScholaFly

CH07-07 Chemistry Watch

Limiting reactants (Higher)

Watch on YouTube

In this lesson

Limiting reactants: how to identify the limiting reactant in a reaction and use it to calculate the mass of product formed. AQA 8462, Edexcel 1CH0 and OCR J248 GCSE. Moles and masses 7 of 7. More at https://scholafly.com

By the end: Identify the limiting reactant in a reaction and use it to calculate the mass of product formed, explaining why the other reactant makes no difference once it is in excess.

What it covers

  1. 0:00 Intro: limiting reactants
  2. 0:31 Limiting reactants: one reactant runs out
  3. 2:15 Compare moles, never masses
  4. 4:23 Limiting reactants: a two to one ratio
  5. 6:37 Explaining why a reaction stops

Key words

About this video

Limiting reactants (Higher) | GCSE Chemistry | CH07-07

Limiting reactants: how to identify the limiting reactant in a reaction and use it to calculate the mass of product formed.
AQA 8462, Edexcel 1CH0 and OCR J248 GCSE. Moles and masses 7 of 7.
More at https://scholafly.com

Watch first: CH07-04 - https://youtu.be/lf6rYWwN3ko, CH07-05 - https://youtu.be/H0fMXUUUbr8
Video code: CH07-07 (search "ScholaFly CH07-07")

#GCSEChemistry #MolesAndMasses #LimitingReactants

For teachers
This GCSE Chemistry lesson teaches limiting reactants (Higher). By the end, students should be able to identify the limiting reactant in a reaction and use it to calculate the mass of product formed, explaining why the other reactant makes no difference once it is in excess. It works through three worked examples and the mistakes examiners report.

Exam board specification references:
AQA 8462
- 4.3.2.4
Edexcel 1CH0
- 1.52
OCR J248
- C3.1k
- C3.1l

Read the transcript

Pour a splash of vinegar onto a heap of bicarbonate of soda. It fizzes hard, then stops. Why did it stop? Most of the white heap is still sitting there. It's tempting to say the bicarb has gone dead, or that the reaction wore itself out. Neither is true. Pour on more vinegar and it fizzes all over again. Keep an eye on that leftover white heap until the end.

This video is Higher only, for combined science and separate chemistry alike. The video on calculating a mass from a balanced equation assumed there was always enough of everything else. This video drops that assumption. In most real reactions, one reactant runs out first. That's the limiting reactant, and it alone decides how much product forms. The other reactant is in excess: there's more of it than can react, and the extra changes nothing. Picture six zinc atoms and four acid particles, reacting in pairs. Four pairs react, the acid is gone, and two zinc atoms are left with nothing to pair with. Two students explain why it stopped. One writes: both reactants were used up. The other writes: the acid was used up, so no more hydrogen could form. Which of those two explanations is the right one? The second. It names one reactant, and the zinc left over proves the other one didn't run out. One examiner's report says: Some students did not gain the last marking point because they referred to both reactants being used up at the end of the reaction rather than just one reactant or it being a limiting factor. The way to word it is to name one reactant: the acid was used up, so no more product could form.

To find the limiting reactant, compare moles, never masses. First turn each mass into moles. Then divide each reactant's moles by its own balancing number. The smaller answer belongs to the limiting reactant. Zinc and acid first. Six point five grams of zinc is added to sulfuric acid holding four point nine grams of H two S O four. Zinc, solid, plus H two S O four, aqueous, gives zinc sulfate, aqueous, plus hydrogen gas. Zinc is six point five over sixty-five, nought point one nought moles. The acid's M r is two plus thirty-two plus sixty-four, ninety-eight, so four point nine over ninety-eight is nought point nought five moles. Both balancing numbers are one. Which reactant is limiting, zinc or the acid? The acid. Its answer is the smaller one. Here the acid also had the smaller mass, but that's a coincidence. Masses can point the wrong way, and the next example shows it. Now use the limiting reactant only. One mole of acid gives one mole of hydrogen, so that's nought point nought five moles of H two. Hydrogen gas has an M r of two, so it's nought point one nought grams of hydrogen. One examiner's report says: This reacting mass calculation where students had to identify the limiting reagent proved very challenging. Only a small percentage of students were able to show that aluminium was the limiting factor. Although there were several methods available to students, many attempted to use more than one method to get to the answer. The fix is one method, the same every time: moles, divide by the balancing numbers, and the smaller answer is limiting.

Now a two to one ratio, where the masses mislead. Seven point nine five grams of copper two oxide is heated with nought point nine nought grams of carbon. Two C u O plus C gives two C u plus C O two. There's far less carbon by mass. Is the carbon the reactant that runs out? No. Carbon atoms are light, so even a small mass holds a lot of them. Only the moles can decide. Copper oxide's M r is sixty-three point five plus sixteen, seventy-nine point five. Seven point nine five over that is nought point one nought moles. Carbon is nought point nine nought over twelve, nought point nought seven five moles. Copper oxide or carbon: after dividing by the balancing numbers, which is limiting? Copper oxide. Its result after dividing by two is the smaller one. That's nought point one nought over two, nought point nought five, against carbon's nought point nought seven five over one. So the carbon is in excess. It stays out of every step except the very last one. Copper oxide to copper is two to two, so there are nought point one nought moles of copper. Times sixty-three point five, that's six point three five grams of copper. The last step asks how much carbon is left over. It's the one place the excess reactant comes back. Nought point one nought moles of copper oxide needs how much carbon, and what's left? It needs nought point nought five moles, half as much. That leaves nought point nought two five moles, which is nought point three nought grams.

Marks in this topic also go on explaining why a reaction stops, with no numbers at all. Magnesium ribbon is dropped into dilute hydrochloric acid. The fizzing slows and stops, while a piece of ribbon is still in the beaker. A student writes: the acid got too weak to react. What really happened to the acid, in the words that earn the mark? It was used up. The acid was the limiting reactant, so no more hydrogen could form, and the metal left over is in excess. Now one more: what would restart it, more magnesium, more acid, or a bigger beaker? More acid. Topping up what ran out restarts it, while extra magnesium or a bigger beaker does nothing. One examiner's report, on a question where gas from marble chips was collected in a syringe, records: Many responses incorrectly stated that sixty centimetres cubed was the maximum amount of gas that was in the chips or it's the maximum volume the syringe can hold. The fix is to blame a reactant, never the apparatus, and to name which one ran out. Every reaction here goes to completion; one that stops with both reactants left is a different topic, reversible reactions.

The vinegar on the bicarb stopped for the same reason: the vinegar was the limiting reactant, and the bicarb was in excess. These last three mix the explaining with the calculating. In words, why does a reaction stop when a reactant is limiting? That one reactant is used up, so no more product can form. Here's a different one: four moles of H two, three of O two. Which is limiting? The hydrogen. Four over two is two, which is smaller than three over one. Then one more: how many moles of water can form? Four moles, one water for every H two.

Limiting reactants closes the list, and every row has its tick. If you've fully understood it, your thumbs-up drops it off your revision list. If it hasn't landed yet, keep it saved and try those three questions again tomorrow, without the video.

That completes our chapter on relative mass, moles and reacting masses. Next chapter: Concentration, yield and atom economy. Hopefully that's next in your feed, but if not, search for ScholaFly C H oh eight, oh oh.

Every other video is on scholafly.com too, easy to search by video code or by keyword. Whatever you're revising, go there and have a look, or, watch the next video.

Related terms

For: AQA GCSE 8462, Edexcel GCSE 1CH0, OCR GCSE J248

On the specification

BoardSpecStatement
AQA GCSE 84624.3.2.4Limiting reactants
Edexcel GCSE 1CH01.52Explain why, in a reaction, the mass of product formed is controlled by the mass of the reactant which is not in excess
OCR GCSE J248C3.1kDeduce the stoichiometry of an equation from the masses of reactants and products and explain the effect of a limiting quantity of a reactant
OCR GCSE J248C3.1lUse a balanced equation to calculate masses of reactants or products
For teachers

This GCSE Chemistry lesson teaches limiting reactants (Higher). By the end, students should be able to identify the limiting reactant in a reaction and use it to calculate the mass of product formed, explaining why the other reactant makes no difference once it is in excess. It works through three worked examples and the mistakes examiners report.